1984-2015 Jeep Upper Ball Joints (Single)

Fits

Ball joints are one of those aftermarket parts that you want to make sure are top quality. A bad ball joint can leave you stranded out on the highway, the trail, or the drag strip that sucks! EMF specializes ball joints so you can trust these units to keep you driving! 

Part Number: EMF-3134/ EMF-3134.1(Oversized)

• Sold individually
• 4140 HTSR material
• Liquid Salt Bath Nitriding
• 30% strength increase
• Removable race and pin
• Black oxide corrosion resistant coating that also resists galling
• Fully greaseable, serviceable & rebuildable

• 7460-4007 Upper Ball Joint Installation Tool is required if your ball joint press kit is not equipped with a die with an ID minimum of 1.93” and a minimum depth of 0.86”. 
• The EMF-K3134 joint can be pressed into place by a die resting on the cap, however it risks damaging the cap threads, leading to the possibility of not being able to rebuild or tighten the joint.  This is your call if you want to purchase the tool or not - EMF is not responsible for damage to the cap that may occur during install without this tool. 

• Life-Time Warranty against Material and Manufacturers Defects. EMF will replace part of or the entire unit if it is determined to be an issue that falls under this category. The customer is encouraged to contact EMF directly to determine the cause of the fault and to receive warrantied products.

• Warranty does not cover breakage due to misuse of the product, improper installation or as a result of another component failure on the vehicle.

• EMF Ball Joints are meant to be rebuilt, which means the internal races and pin will wear over time under normal circumstances. The internal race and pin components are not covered by replacement Warranty unless it is determined there is a manufacturer defect that caused premature wear. In order to maximize your product life, regular maintenance which includes tightening of the cap and greasing are required.